PME Tolerance

From: Lesli Oiling Mark (Lesli.Mark_at_colorado.edu)
Date: Mon Feb 19 2018 - 10:03:48 CST

• Next message: Alex Saad-Falcon: "Simple PME Question"
• Previous message: Aashish Bhatt: "Re: FAD topology and parameters"
• Next in thread: Brian Radak: "Re: PME Tolerance"
• Reply: Brian Radak: "Re: PME Tolerance"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi,

I was wondering if the PME tolerance is not specified (or just commented
out in the configuration file) it the program uses a default value of 10^-6
PME tolerance?

Thanks,

Lesli

• Next message: Alex Saad-Falcon: "Simple PME Question"
• Previous message: Aashish Bhatt: "Re: FAD topology and parameters"
• Next in thread: Brian Radak: "Re: PME Tolerance"
• Reply: Brian Radak: "Re: PME Tolerance"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.6 : Mon Dec 31 2018 - 23:20:52 CST